This is an old revision of the document!
You can use crYOLO either by command line or by using the GUI. The GUI should be easier for most users. You can start it with:
The crYOLO GUI is basically a visualization of the commandline interface. On left side, you find all possible “Actions”:
Each action has several parameters which are organized in tabs. Once you chosen your settings you can press “Start”, the command will be applied and crYOLO shows you the output:
It will tell you when something went wrong. Pressing “edit” brings you back to your settings, where you can either edit the settings (in case something went wrong) or go to the next action.