cryolo_release_note_110
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
cryolo_release_note_110 [2018/08/23 11:47] twagner [Changes crYOLO Boxmanager] |
cryolo_release_note_110 [2018/08/23 13:10] twagner [Training] |
||
|---|---|---|---|
| Line 15: | Line 15: | ||
| ===== Picking filaments - Using a model trained for your data ===== | ===== Picking filaments - Using a model trained for your data ===== | ||
| + | Since version 1.1.0 crYOLO supports picking filaments. | ||
| ==== Data preparation ==== | ==== Data preparation ==== | ||
| Line 32: | Line 33: | ||
| ==== Training ==== | ==== Training ==== | ||
| - | In principle, there is not much difference in training crYOLO for filament picking and particle picking. However, in our experience the warm-up phase and training need a little bit more time: | + | In principle, there is not much difference in training crYOLO for filament picking and particle picking. For project with roughly 20 filaments per image we successfully trained on 40 images (=> 800 filaments). However, in our experience the warm-up phase and training need a little bit more time: |
| **1. Warm up your network** | **1. Warm up your network** | ||
cryolo_release_note_110.txt ยท Last modified: 2018/08/24 08:19 by twagner
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: GNU Free Documentation License 1.3
