cryolo_config

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
cryolo_config [2019/09/13 18:49]
twagner
cryolo_config [2019/10/11 17:51] (current)
twagner
Line 15: Line 15:
   * #05 ''​overlap_patches'':​ Optional. Only needed when using patch mode. Specifies how much the patches overlap. In our lab, we always keep the default value.   * #05 ''​overlap_patches'':​ Optional. Only needed when using patch mode. Specifies how much the patches overlap. In our lab, we always keep the default value.
  
-  * #06 ''​num_patches'':​ Optional. If specified the patch mode will be used. A value of "​2"​ means, that 2x2 patches will be used.+  * #06 ''​num_patches'':​ Optional. If specified the patch mode will be used. A value of "​2"​ means, that 2x2 patches will be used. With PhosaurusNet you typically don't need it.
  
   * #07 ''​filter'':​ Optional. Specifies the absolute cut-off frequency for the low-pass filter and the corresponding output folder. CrYOLO will automatically filter the data in ''​train_image_folder''​ ''​valid_image_folder''​ and save it into the output folder. It will automatically check if a image provided in the train_image_folder is already filtered and use it in case. Otherwise it will filter it.   * #07 ''​filter'':​ Optional. Specifies the absolute cut-off frequency for the low-pass filter and the corresponding output folder. CrYOLO will automatically filter the data in ''​train_image_folder''​ ''​valid_image_folder''​ and save it into the output folder. It will automatically check if a image provided in the train_image_folder is already filtered and use it in case. Otherwise it will filter it.
  • cryolo_config.txt
  • Last modified: 2019/10/11 17:51
  • by twagner