This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
janni_tutorial [2019/09/16 09:10] twagner [Start JANNI] |
janni_tutorial [2019/09/16 09:18] twagner [Start JANNI] |
||
---|---|---|---|
Line 20: | Line 20: | ||
</ | </ | ||
- | {{ :: | + | The GUI is basically a visualization of the command line interface: |
+ | |||
+ | {{ :: | ||
+ | |||
+ | On the left side, you can see all available actions: | ||
+ | * **config**: To create a config file, which is needed to train JANNI. | ||
+ | * **train**: This action let you train a model for your data. | ||
+ | * **denoise**: | ||
+ | |||
+ | Each action has several parameters which are organized in tabs. Once you chosen your settings you can press “Start”, | ||
+ | |||
+ | It will tell you when something went wrong. Pressing “edit” brings you back to your settings, where you can either edit the settings (in case something went wrong) or go to the next action. | ||
==== Training a model for your data ==== | ==== Training a model for your data ==== | ||
In case you want to use the general model ([[janni# | In case you want to use the general model ([[janni# |