This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
downloads:cryolo_1 [2019/03/17 20:04] twagner [Run it on the CPU] |
downloads:cryolo_1 [2019/03/29 11:47] twagner [Installation] |
||
---|---|---|---|
Line 30: | Line 30: | ||
====crYOLO==== | ====crYOLO==== | ||
- | Version: 1.3.0 | + | Version: 1.3.1 |
- | Uploaded: | + | Uploaded: |
- | [[ftp:// | + | [[ftp:// |
====crYOLO boxmanager==== | ====crYOLO boxmanager==== | ||
Line 90: | Line 90: | ||
* < | * < | ||
* < | * < | ||
- | * Issue 15: If the --gpu_fraction is used, crYOLO always uses GPU 0. Will be fixed in 1.3.1. | + | * <del>Issue 15: If the %%--%%gpu_fraction is used, crYOLO always uses GPU 0. Will be fixed in 1.3.1.</ |
+ | * Issue 16: %%--%%gpu_fraction only works for prediction, not for training. Will be fixed in 1.3.2. | ||
+ | * Issue 17: On the fly filtering (%%--%%otf) is slower than using it not, as the filtering is not parallelized in this case. | ||
Line 109: | Line 111: | ||
**Install crYOLO!** | **Install crYOLO!** | ||
- | The following instructions assume that pip and [[https:// | + | The following instructions assume that pip and [[https:// |
In case you have a old cryolo environment installed, first remove the old one with: | In case you have a old cryolo environment installed, first remove the old one with: | ||
< | < | ||
Line 126: | Line 128: | ||
Install crYOLO: | Install crYOLO: | ||
< | < | ||
- | pip install numpy | + | conda install numpy==1.14.5 |
pip install cryolo-X.Y.Z.tar.gz | pip install cryolo-X.Y.Z.tar.gz | ||
pip install cryoloBM-X.Y.Z.tar.gz | pip install cryoloBM-X.Y.Z.tar.gz | ||
Line 155: | Line 157: | ||
Use the **__'' | Use the **__'' | ||
- | ====== Change log ===== | + | ====== Change log ====== |
====crYOLO==== | ====crYOLO==== | ||
+ | |||
+ | **crYOLO 1.3.1:** | ||
+ | * Fix Issue 15: -g was ignored when --gpu_fraction was used. | ||
**crYOLO 1.3.0:** | **crYOLO 1.3.0:** |